The Grids tab allows you to create, modify, remove and visualize the manufacturing grids of a lens.
...
By default all deleted grids are hidden.
The red Delete all button is used to delete all visibles manufacturing grids in the table due to filters for example.
The blue Update all button is used to modify small parts of the grid definition such as:
The grids range of the lens (for a change of range for example)
Theminimal, maximum as well as the step additions.
The first and last validity dates
The balance lens availability (Yes/No)
The step to use in the catalog
If there is a discount on the lens (Yes/No) - dedicated to SF6 only
The blue + button allows to add a new manufacturing grid definition (see the right side of the table below).
...
In this view, you can enter the status of the edited grid. See the documentation: IWICATALOG - Statut et état des produits.Status and situation of the products
Grid definition
In this part you can indicate the datas of your manufacturing grid.
Chose the available diameters in your grid. The list suggest the existing diameters in the parameters. To add one or more diameter(s) on the grid, you must click on the blue Add diameter button. The blue + button allows to add a new diameter that doesn't exist already. For further information, you can go on the following page: IWICATALOG - Paramètres Parameters: Onglet GrillesGrids tab
Indicate the manufacturer grid of the lens. If the range does not exist you can click on th blue + button to create a new one or follow this link: IWICATALOG - Paramètres : Onglet Grilles.Parameters: Grids tab
Enter the minimal and maximum terminals of the spheres and the cylinders.
Specify the used step
Indicate the maximum prism (only for the SF6 that will allow to define the values of different prisms according to manufacturing grids)
Entre the minimum and maximum additions and the step (according to the lens type)
Automatic processing: Yes/No indicator
Possibility of balancing: Yes/No Indicator
...
Minimal cylinder
Minimal sphere. 1 : the minimal sphere 4 will be automatically entered without slope calculation
Maximum sphere 2
Maximum cylinder 6 : the maximum sphere 3 will be automatically calculated while taking into account the slope. This is an input help for most production grids.
There is a blue + button in the additions line. This one allows you to put several addition lines in case you have addition steps according to its power.
...
To fill in this part is identical to that of the manufacturing grids except that you will have to enter the necessary information for the bending bases by ticking the desired value(s). If the bending base is not available, you can create a new one by clicking on the blue + button. You can also go to: IWICATALOG - Paramètres : Onglet Grilles.Parameters: Grids tab
