IP (RJ-45/RJ-45) 

Tracer is connected to the same network as the computer. In this case, if no device uses tracer, it is supposed to appear in tab My Tracers. Table is updated every 5 seconds.
In the case where tracer is not visible but normally accessible (application can sometimes be denied listening to the tracer), you can manually set tracer by specifying its IP address. We can check before tracer can be ping.

Example with Windows command prompt:

Then tracer must be parameterized with correct IP address. Port must be 50000 according to OMA standard.

Validation allows the recording of tracer and proposes a connection assistant. If settings are right, connection should go smoothly.